 |
 |
E-mail:info@kingkong88.com
Web：www.kingkong88.com TEL：0769-82252556
Address：Room 313, Building 1, Yifang Industrial Park（Park 138）, Hongye North No.1 Road, Tangxia Town, Dongguan City, Guangdong Province
   
|
|
|
 |
|
The headset has only one side to ring the solution
|
|
Edit: Click: 624 Date: 2016-09-30
|
|
Often can see friends have asked, "I have only one side of the headphones have a sound ah?", "Headphones side of the sound how to do ah?", "How my headphones have a sound, what did not sound, intermittent? ". As a professional headset manufacturer, headset manufacturers in Shenzhen Lin Lin Yan Xiaobian feel the need for these friends to answer. Please take a few minutes to see, perhaps to help you.
Headset as a consumable, in use for some time is likely to be such and such problems, if the headset is even more inferior. Of course, and their habits are very related. Such as accidentally pulling the headset, often do not pay attention, leading to headphone plugs and other bending will reduce the life of the headset. If the other parts of the headset is also good, the plug contact failure or poor contact lead to the need to re - buy a headset, a bit of waste, of course, Tu Hao please automatically ignore my words.
First of all make sure your headset is not the warranty period, if the early warranty period, then, do not need trouble. Secondly you also need a little tool: a small scissors, a hot melt adhesive, a lighter, a little rosin or solder paste (flux), electric iron.
Step 1: Use the scissors to carefully cut the root of the headphone pin to expose the solder joint.
Step 2: Use the scissors to clean the plastic at the root of the pin.
The third step: the other end of the headset line open, exposing four wires (enameled wire)! The red line is the right (R +) channel, the green line is the left (L +) channel, the two yellow lines are the common ground (G-), and the flux is tinned on their surface.
Step 4: Wires are to be soldered to the pins. The top and bottom are green (L), red (R) and yellow (G). All 3.5mm stereo plugs are the same.
Step 5: melt the hot melt adhesive bar with a lighter, the weld joints with a good hot melt adhesive wrap.
Step 6: Re-use the lighter will be a good hot melt adhesive melt, quickly back into the casing (note the hands do not touch the hot melt adhesive, although not burn, really very hot, you absolutely do not want to experience ), Cooling, and finally clean up the excess hot melt adhesive to be done.
When handled properly, the basic can reach more than 90 percent before the sound quality, if you are not headphones enthusiasts, then, not the pursuit of the perfect person. Enough for you to use.
|
|
Prev: Bluetooth speaker manufacturers literacy: What is active speakers?
|
|
Next: none！
|
print |
close
|
|
|
